Mar
05
2008
IBM 31.4 GB Solid State Drive Supported in all Blade Models
Posted by: Aaron Delp in IBM BladesJust a heads up for everyone, the new 31.4 GB Solid State “Disk” (43W7618) for the IBM Blade Servers is supported on the entire product line. The previous generations (16GB single and dual platter) were only supported in the HS21 XM.
Also, this model is a single platter, not a dual platter (think RAID 1 within the disk case) and as far as I know a dual platter isn’t in the works for now.
Entries (RSS)
I did some experimental work with the dual 16GB SAS SSD drive last fall on a HS21XM.
When putting them in RAID1, I was able to get 80+ GB/min read, but only 20 GB/min write. With a single IBM 73GB SAS drive, I was able to read and write at around 20 GB/min. With no RAID, and writing directly to a single SSD “disk”, write speeds stayed around 20 GB/min, but the read speed dropped to 40 GB/min (obviously because of the lack of RAID). Above performance data was from tests performed with sequential read/writes. Random reads/writes drew close to the same number (about 20% loss in performance) on the SSD, but HDD speeds dropped considerably.
Basically, the 16 GB SSD drive pack was great at many small random reads, but any writing is slow as molasses.
Err, the 73 GB SAS drive read and wrote at close to 40 GB/min (not 20 GB). Oops.
Good Morning Jason and thank you for your comments! Now that you mention it I remember sitting on a technical call when it was introduced. The reason for the slow write performance is because of the technology used to actually write. I don’t remember the details but basically it had to do an erase of the sector before it did the write and then I believe it did a checksum after the fact. Anyway, I remember IBM saying there were multiple operations when a write happens and yes, write would be slow with the first generation of the drives.
We were told at the time that this will improve in future generations.
Thank you for your comment!!